Pianos regularly make movers yearly list of products that are most regularly harmed. Grand pianos are particularly bothersome. Practicing the following treatments for dismantling, padding and loading grand pianos will prevent damage, lower claims cost, and improve customer satisfaction.
1) A minimum of 3 individuals are needed to handle a baby grand piano. If the child grand piano needs to go up or down stairs or if a full or performance grand piano requires to be transported, a minimum of 4 individuals are required.
2) Constantly complete a accurate and extensive inventory. It might be preferable or essential to utilize a visual inventory to adequately explain and reveal pre-existing damage.
3) As different parts are dismantled, please location all hardware in a correctly identified parts bag and then put the parts bag in a "Components Box".
4) Remove the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a clean furnishings pad.
5) Detach the lid by eliminating the hinge pins. Have one individual wiggle the lid, holding it opposite the hinge, while a 2nd individual works the pin loose. Please be careful not to damage the wood with the pliers or with the pin itself. If essential, cover the jaws of the pliers with a small cloth to assist prevent damage to the wood. Wrap the lid in a clean furnishings pad.
6) Get rid of the prop that holds the cover open and cover it in a tidy furnishings pad. The prop has a hinge pin and is in two pieces.
7) Eliminate the pedal assembly and wrap it in a tidy furnishings pad. When getting rid of the screws, please be cautious not to drop the braces. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by putting a piece of masking tape with the suitable number on each rod.
8) Pad the piano by putting a clean rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to prevent it from flopping open while you deal with the piano. Keep in mind: Please ensure that the surface of the piano is dust-free before padding it.
9) Position a piano board and connect the straps so that it is all set to get the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.
10) Get rid of the left front leg by placing one person underneath the piano at the left end of the keyboard. Be sure to have two individuals lifting the corner of the piano while the 3rd person removes the leg. Keep in mind: Please be sure to note which legs were removed from which positions since some pianos have legs that are not interchangeable.
11) Place the piano on the piano board imp source by decreasing the "leg-less" end onto the board. Please make sure to lift the whole piano slightly while completing this maneuver to prevent excessive pressure on the remaining, attached legs as the piano ideas. Lift the piano to an upright position on the board. Keep in mind: Please make sure that the soundboard is safe and secure prior to raising. Be sure that the piano is centered comfortably against the brace at the end of the piano board. Note: his comment is here Never ever leave the piano unattended. Constantly have at least a single person holding the piano consistent at all times.
12) Get rid of the 2 remaining legs and wrap them in tidy furniture pads. These legs are held in place by a "essential and slot" plan. To eliminate the leg, slide it inward towards the center of the piano till it comes out of the slot.
13) Secure the piano to the piano board by bringing the ends of the straps together and securing them. Place folded burlap pads over the furniture pads but under the straps to offer additional security to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, connect the loose ends of the 2 straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for protection versus residence damage, place the keyboard end of the piano towards the bottom of the stairs. Connect a hump strap to the top end official site of the piano board to avoid the piano from slipping.
16) To fill the piano, leave it on the piano board and location it in a tier as the very first base item with the keyboard facing the wall of the preceding tier. The very best location to pack the padded cover is between the piano and the preceding tier or between the piano and the wall.
Although grand pianos represent a considerable challenge, they can be moved without damage by utilizing good sense and practicing the procedures noted above.